닫기

Frsky RX8R PRO


X8R에 추가기능을 탑재한 신형 RX8R PRO입니다.
PWM으로 8채널, SBUS로 16채널까지 가능합니다.
RX8R 두 개를 연결하여 PWM 16채널을 사용할 수 있습니다.
redundancy기능이 있어, 수신기 두 개를 연결하였을때, 하나가 수신을 잃어도 다른 하나가 연결되어 있습니다.
기존 제품보다 정밀도가 높아지고 지연시간이 낮아졌습니다.
PWM 편차가 0.5us 감소하여, 기존 X8R 보다 9ms 빨라졌습니다.
작동전압은 4V-10V입니다.
무게는 12.1g입니다.

<구성>

수신기 1개


The FrSky RX8R Pro is an upgraded version of RX8R receiver, it has all the same features including redundancy. The new 'Pro' version has higher precision and lower latency. Its deviation of PWM is reduced to 0.5us, and the delay of PWM output is 9ms less than that of the X8R in high-speed mode. Another feature that is new with the RX8R Pro is the reduction of interference caused by the ignition process.

Specifications

Dimension : 46.3mm * 26.6mm * 14.2mm ( L* W *H )
Weight : 14.8g
Numbers of Channels : 16CH (1~8CH PWM or 9~16CH PWM from conventional channel outputs, 1~16CH from SBUS port)
With RSSI Output on Board : Analog DC 0 ~ 3.3V
Operating Voltage Range : 3.5V ~ 10V
Operating Current : 100mA@5V
Operating Range : full range (>1.5km)

Firmware Upgradeable
Servo Frame Rate : 9ms (HS— High-Speed Mode) / 18ms (FS—Normal Speed Mode)
Compatibility : FrSky transmitters / transmitter modules in D8/D16 mode

Features
Strong anti-interference performance in ignition process
Higher precision of PWM
Lower latency on the PWM output
Support redundancy function
Smart Port enabled and support telemetry data transmission

The Redundancy Function
For the master and slave receivers,

when the master receiver goes into failsafe, the output signal from the slave receiver will be used until the master receiver works again.

Note : When both the master and slave receivers go into failsafe,

the failsafe signal from the master receiver will be output; The slave receiver should be in no telemetry mode.